HP LH4r HP Netserver LXr 8500 PCI Hot Plug Utility Guide - Page 40
Replacing a Hot Plug Board, Removing PCI Boards
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Appendix B Warranty, Software License and Support CAUTION When handling electronic components, wear a wrist strap and use a static-dissipating work surface connected to the chassis when handling components. Ensure the metal of the wrist strap contacts your skin. 10. Grasp the edge of the PCI board firmly and pull upward. See Figure 27. Try to pull the board straight up without wiggling it side to side along the length of the board. Remove board Ensure PCI hold-down latch is at least half open before removing board. Figure 27. Removing PCI Boards 11. Place the PCI board on a static free surface. 12. Go to the next section "Replacing a PCI Hot Plug Board" to install a new, but identical PCI Hot Plug board in the PCI slot. Replacing a Hot Plug Board Use this topic to replace a PCI Hot Plug Board. The following conditions must be met before replacing a PCI Hot Plug Board: 36