HP LH4r HP Netserver LXr 8500 PCI Hot Plug Utility Guide - Page 47
Manager Console NCMCON user interface., board is working correctly.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Chapter 2 PCI Hot Plug Utility for Novell NetWare Amber Green LED LED On Off Off Off Slot Status Active Powered Off (wrong board or no board) Powered Off Indicates This Status Power to the slot is on, and the slot is operating normally. Do not remove the board from the slot. Power to the slot is off, but the Amber LED is on, due to a failure in the Hot Replacement process. Typically this is the result of installing the wrong board, because the replacement board must be the same type as the original PCI board. This also occurs if the board is removed, emptying the slot, and power is turned on. You can safely remove the board from this slot. Power to the slot is off. You can safely remove the board from this slot. 7. If you replaced a Disk Drive Controller board, causing it to dismount its disk drives, re-mount the disk drives to ensure the Disk Drive Controller board is working correctly. Remounting the drives must be done outside the Novell Configuration Manager Console (NCMCON) user interface. 8. If you are assured of the PCI board's operation, including its driver, continue with the next step. 9. If all desired Hot Plug boards have been replaced, replace the PCI access panel (refer to your Installation Guide). CAUTION To prevent damage to cables, use caution when sliding the chassis into the rack, if the Cable Management Arm is not used. 10. Slide the chassis slowly back into the rack (refer to your Installation Guide). 11. Return the HP NetServer to normal operation (refer to your Installation Guide). 43