HP LH4r HP Netserver LXr 8500 PCI Hot Plug Utility Guide - Page 35
Removing a Hot Plug Board, Powered
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Chapter 2 PCI Hot Plug Utility for Novell NetWare PCI Hot Plug LED Indicators Attention (Amber) Power P10 P9 P8 P7 P6 P5 P4 P3 P2 P1 Figure 23. PCI Slots and LED Indicators Table 6. PCI (Hot Plug) LED Code (Rear of Chassis) Amber LED Off On Off Green LED On Off Off Slot Status Indicates This Status Ready Powered on, but no driver loaded for board. Do not remove the board from the slot. Powered On The PCI slot just power on, but the driver initiation is not complete yet. This only happens momentarily prior to completing driver loading. Do not remove the board from the slot. Active Power to the slot is on, and the slot is operating normally. Do not remove the board from the slot. Powered Off (wrong board or no board) Power to the slot is off, but the Amber LED is on, due to a failure in the Hot Replacement process. Typically this is the result of installing the wrong board, because the replacement board must be the same type as the original PCI board. This also occurs if the board is removed, emptying the slot, and power is turned on. You can safely remove the board from this slot. Powered Power to the slot is off. You can safely remove the 31