HP LaserJet 6p/mp Service Manual - Page 113
DC Controller
View all HP LaserJet 6p/mp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
Note DC Controller 1 Remove the Printer Covers. 2 Disconnect the motor connector from the motor (Figure 6-39, callout 1). 3 Disconnect the Solenoid connector from the DC Controller (Figure 6-22, callout 1). 4 Remove the back sheet metal plate and disconnect the PS202/PS204 connector (Figure 6-29). 5 Remove the AC Cable cover and disconnect the AC Cable from the DC Controller (Figures 6-13 and 6-14). 6 Tip the printer on its top, with the front facing you. 7 Remove the (4) screws (Figure 6-40, callout 1). On some models, one of the screws is a grounding screw. The location of the grounding screw is marked by a "star" etched into the bottom of the DC Controller. If the model being serviced has a grounding screw with a washer, make sure that the grounding screw is replaced in the same location when reinstalling the DC Controller. 1 Figure 6-40 DC Controller removal (1 of 3) EN Bottom assemblies 111