HP OMEN 17-cb0000 Maintenance and Service Guide - Page 58
Power button board, Remove the two Phillips M2.0 × 3.0 screws
![]() |
View all HP OMEN 17-cb0000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Power button board NOTE: The power button board spare part kit does not include the cable. The cable is available as spare part number L57364-001. Table 6-9 Power button board description and part number Description Spare part number Power button board L57371-001 Before removing the power button board, follow these steps: 1. Prepare the computer for disassembly (Preparation for disassembly on page 29). 2. Remove the bottom cover (see Bottom cover on page 30). 3. Remove the battery (see Battery on page 38). 4. Remove the solid-state drive (see Solid-state drive and Optane memory module on page 32). 5. Remove the fan/heat sink (see Heat sink/fan assembly on page 44). Remove the power button board: 1. Remove the two Phillips M2.0 × 3.0 screws (1) that secure the board to the computer. 2. Rotate board upside down so you can access connector underneath (2). 3. Disconnect the cable from the ZIF connector on the board (3). 4. Remove the power button board from the computer (4). Reverse this procedure to install the power button board. IMPORTANT: When replacing the power button board, be sure to replace the tape so the internal light does not show. 48 Chapter 6 Removal and replacement procedures for authorized service provider parts
![](/manual_guide/products/hewlettpackard-omen-17cb0000-maintenance-service-guide-5fdb4dc/58.png)