HP OMEN 17-cb0000 Maintenance and Service Guide - Page 62
Display assembly, remove the bezel
View all HP OMEN 17-cb0000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Display assembly NOTE: The display assembly is spared only at the subcomponent level. Before removing the display assembly, follow these steps: 1. Prepare the computer for disassembly (Preparation for disassembly on page 29). 2. Remove the bottom cover (see Bottom cover on page 30). 3. Remove the battery (see Battery on page 38). 4. Remove the fan/heat sink (see Heat sink/fan assembly on page 44). 5. Remove the system board (see System board on page 49). Remove the display assembly: 1. Remove the wireless antenna cables from the clips that secure them to the computer chassis (1). 2. Remove the two Phillips M2.5 × 5.0 screws (2) from each hinge. 3. Open the computer (3), and then separate the display from the computer (4). 4. If it is necessary to replace display assembly subcomponents, first remove the bezel: a. Release the top edge of the display bezel (1) from the display assembly. IMPORTANT: Be careful not to bend or break the narrow sections of the bezel when removing. b. Release the left and right edges of the display bezel (2) from the display assembly. c. Release the bottom edge of the display bezel (3) from the display assembly. 52 Chapter 6 Removal and replacement procedures for authorized service provider parts