HP Scanjet 200 User Guide - Page 29

Safety instructions, Never disassemble, modify, or attempt to repair the scanner by yourself except

Get HP Scanjet 200 PDF manuals and user guides View all HP Scanjet 200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 29 highlights

Safety instructions Important safety instructions Read all these instructions, and follow all warnings and instructions marked on the scanner. • In this document, warning, cautions and notes indicate the following: ◦ Warnings must be followed carefully to avoid bodily injury. ◦ Cautions must be observed to avoid damage to your equipment. ◦ Notes contain important information and useful tips on the operation of this product. • Place the scanner close enough to the computer for the interface cable to reach it easily. Do not place or store the scanner outdoors, near excessive dirt or dust, water, heat sources, or in locations subject to shocks, vibrations, high temperature or humidity, direct sunlight, strong light sources, or rapid changes in temperature or humidity. Do not use with wet hands. • Use only the type of power source indicated on the product's label. • When connecting this product to a computer or other device with a cable, ensure the correct orientation of the connectors. Each connector has only one correct orientation. Inserting a connector in the wrong orientation may damage both devices connected by the cable. • Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on and off. • If you use an extension cord with the PC system that the scanner is attached to, make sure the total ampere rating of the devices plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's ampere rating. • Never disassemble, modify, or attempt to repair the scanner by yourself except as specifically explained in the scanner's guides. • Do not insert objects into any opening as they may short out parts. Beware of electrical shock hazards. • If damage occurs to the USB plug, replace the USB cable. • Unplug the scanner and refer servicing to qualified service personnel under the following conditions: liquid has entered the scanner; the scanner has been dropped or the case has been damaged; the scanner does not operate normally or exhibits a distinct change in performance. (Do not adjust controls that are not covered by the operating instructions.) • Unplug the scanner before cleaning. Clean with a damp cloth only. Do not use liquid or aerosol cleaners. Safety instructions 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
Safety instructions
Important safety instructions
Read all these instructions, and follow all warnings and instructions marked on the
scanner.
•
In this document, warning, cautions and notes indicate the following:
◦
Warnings must be followed carefully to avoid bodily injury.
◦
Cautions must be observed to avoid damage to your equipment.
◦
Notes contain important information and useful tips on the operation of this
product.
•
Place the scanner close enough to the computer for the interface cable to reach it
easily. Do not place or store the scanner outdoors, near excessive dirt or dust,
water, heat sources, or in locations subject to shocks, vibrations, high temperature
or humidity, direct sunlight, strong light sources, or rapid changes in temperature
or humidity. Do not use with wet hands.
•
Use only the type of power source indicated on the product’s label.
•
When connecting this product to a computer or other device with a cable, ensure
the correct orientation of the connectors. Each connector has only one correct
orientation. Inserting a connector in the wrong orientation may damage both
devices connected by the cable.
•
Avoid using outlets on the same circuit as photocopiers or air control systems that
regularly switch on and off.
•
If you use an extension cord with the PC system that the scanner is attached to,
make sure the total ampere rating of the devices plugged into the extension cord
does not exceed the cord’s ampere rating. Also, make sure the total ampere rating
of all devices plugged into the wall outlet does not exceed the wall outlet’s ampere
rating.
•
Never disassemble, modify, or attempt to repair the scanner by yourself except as
specifically explained in the scanner’s guides.
•
Do not insert objects into any opening as they may short out parts. Beware of
electrical shock hazards.
•
If damage occurs to the USB plug, replace the USB cable.
•
Unplug the scanner and refer servicing to qualified service personnel under the
following conditions: liquid has entered the scanner; the scanner has been
dropped or the case has been damaged; the scanner does not operate normally or
exhibits a distinct change in performance. (Do not adjust controls that are not
covered by the operating instructions.)
•
Unplug the scanner before cleaning. Clean with a damp cloth only. Do not use
liquid or aerosol cleaners.
Safety instructions
27