HP Surestore Disk Array 12h HP SureStore E Disk Array 12H User's and Service M - Page 196
Backplane AssemblyŒHP-qualified personnel only
View all HP Surestore Disk Array 12h manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 196 highlights
Removal and Replacement Backplane Assembly-HP-qualified personnel only Backplane Assembly-HP-qualified personnel only CAUTION! The following procedures require that you perform a shutdown, turn off the disk array, and make it inaccessible. Check with the system administrator before proceeding. To replace the backplane assembly (see Figure 33, Item 2): 1. Shut down the disk array, turn off the disk array, disconnect the ac power cords and SCSI interface cables. 2. Remove all modules (fans, disks, power supplies, and controllers) from all bays. 3. Remove the two rear cover captive screws, as shown in Figure 33, Item 6. Tilt back the top of the rear cover (5) and remove the rear cover completely from the disk array (1). 4. Remove the four standoffs (3) and their lock washers. Note carefully the position of the standoffs for later reassembly. 5. Remove the two T-15 M4 screws (4) that secure the display module to the backplane assembly. 6. Remove the display module from the front of the disk array. 7. Remove the eleven M4 nuts (8) from the backplane assembly. Note that the three nuts across the top of the backplane assembly also have flat washers (7) beneath the nuts. Do NOT remove any Pozidriv or Phillips screws from the backplane! 8. Remove the backplane assembly (2). 9. Reassemble in reverse order. Align the push rod with the switch on the backplane assembly and check for proper operation of the power button before attaching all hardware. 196 Removal