HP Surestore Disk Array 12h HP SureStore E Disk Array 12H User's and Service M - Page 64
View Settings, Shutdown Complete
View all HP Surestore Disk Array 12h manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
HP SureStore E Disk Array 12H Controller Firmware Download Procedure 6. Shutdown the array using the front panel. KEY CANCEL CANCEL MENU - - ENTER ENTER DISPLAY "Ready" "Language" "View Settings" "Shutdown" "Confirm" "Shutdown Complete" After shutdown has completed, push the on/off button to the off position completing the shutdown. This will turn off power to all modules. 7. Disconnect all disk drive modules from the back plane. You do not need to remove them completely. Just pull them out so that the cam handle is fully extended. 8. Pull the existing good controller and reset (disconnect and then re-connect) both batteries at the same time. This will mean that the only copy of valid maps reside on the disk drive modules. 9. Install both controllers. Put the controller with the desired firmware into controller slot X. 10. Push the on/off button to the on position and allow the array to complete its initialization process. After the initialization has completed, the front panel should say "Not Enough Disks". Check the system state using the key strokes below. The System state should be "Not Enough Disks" with a "Firmware Needed" warning. KEY CANCEL CANCEL MENU - ENTER + DISPLAY "Not Enough Disks" "Language" "View Settings" "System State: Not Enough Disks" "Warning: Firmware Needed" Controller 64