HP TC1100 HP Compaq tc1100 Tablet PC - Maintenance and Service Guide - Page 132
One PM2.5×11.0 screw that secures the pivot arm hinge, to the bottom case.
View all HP TC1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
Removal and Replacement Procedures 7. Position the docking station with the left side toward you. ✎ Make sure the docking stand and pivot arm are supported before removing the following screws. The docking stand and pivot arm can fall if not supported. 8. Remove the following screws: 1 Two PM2.5×8.0 screws that secure the cable bracket to the bottom case. 2 One PM2.5×11.0 screw that secures the pivot arm hinge to the bottom case. 3 Three PM2.5×8.0 screws that secure the pivot arm hinge to the bottom case. 9. Remove the docking stand and pivot arm 4. Removing the Docking Stand and Pivot Arm 5-42 Maintenance and Service Guide
5–42
Maintenance and Service Guide
Removal and Replacement Procedures
7. Position the docking station with the left side toward you.
✎
Make sure the docking stand and pivot arm are supported
before removing the following screws. The docking stand and
pivot arm can fall if not supported.
8. Remove the following screws:
1
Two PM2.5×8.0 screws that secure the cable bracket to the
bottom case.
2
One PM2.5×11.0 screw that secures the pivot arm hinge
to the bottom case.
3
Three PM2.5×8.0 screws that secure the pivot arm hinge
to the bottom case.
9. Remove the docking stand and pivot arm
4
.
Removing the Docking Stand and Pivot Arm