HP Xw6200 HP Workstation xw6200 Service and Technical Reference Guide (3rd Edi - Page 45

„ Download the latest ROMPaq images from HP driver and support page, http://www.hp.com/support/ files. CAUTION For maximum ROM protection, be sure to establish a setup password. The setup password prevents unauthorized ROM upgrades. System Software Manager allows the system administrator to set the setup password on one or more PCs simultaneously. For more information, visit http://www.hp.com/ go/ssm. Remote ROM Flash Remote ROM Flash allows the system administrator to safely upgrade the ROM on remote HP workstations directly from the centralized network management console. Enabling the system administrator to perform this task remotely, on multiple workstations and personal computers, results in a consistent deployment of and greater control over HP PC ROM images over the network. It also results in greater productivity and lower total cost of ownership. The workstation must be powered on, or turned on through Remote Wakeup, to take advantage of Remote ROM Flash. For more information on Remote ROM Flash, see the HP Client Manager Software or System Software Manager at http://h18000.www1.hp.com/im/prodinfo.html. HPQFlash The HPQFlash utility is used to locally update or restore the system ROM on individual PCs through a Windows operating system. For more information on HPQFlash, visit http://www.hp.com/support/files and enter the name of the workstation when prompted. FailSafe Boot Block ROM The FailSafe Boot Block ROM allows for system recovery in the unlikely event of a ROM flash failure, for example, if a power failure were to occur during a ROM upgrade. The Boot Block is a flash-protected section of the ROM that checks for a valid system ROM flash when power to the system is turned on. „ If the system ROM is valid, the system starts normally. „ If the system ROM fails the validation check, the FailSafe Boot Block ROM provides enough support to start the system from a ROMPaq diskette, which will program the system ROM with a valid image. NOTE Some models also support recovery from a ROMPaq CD. ISO ROMPaq images are included with selected models in the downloadable ROM softpaqs. When the boot block detects an invalid system ROM, the System Power LED blinks RED 8 times, one every second, followed by a 2-second pause. Also, eight simultaneous beeps will be heard. A Boot Block recovery mode message is displayed on the screen (some models). To recover the system after it enters Boot Block recovery mode: 1 If there is a diskette in the diskette drive or a CD in the CD drive, remove the diskette and CD and turn off the power. 2 Insert a ROMPaq diskette into the diskette drive or, if permitted on this workstation, a ROMPaq CD into the CD drive. DESKTOP MANAGEMENT 45 Chapter 3