HP ZBook Studio G3 Maintenance and Service Guide - Page 57
Fingerprint reader board, Disconnect the cable from the system board
![]() |
View all HP ZBook Studio G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Fingerprint reader board Description Fingerprint reader board (includes bracket) Spare part number 840952-001 Before removing the fingerprint reader board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the service door (see Service door on page 30). 5. Remove the bottom cover (see Bottom cover on page 31). 6. Remove the battery (see Battery on page 32). Remove the fingerprint reader board: 1. Disconnect the cable from the system board (1). 2. Lift the tape from atop the fingerprint reader (2). 3. Remove the Phillips PM2.0×3.0 screw that secures the bracket to the computer (3). 4. Slide the bracket downward to disengage it, and then lift the bracket off the fingerprint reader (4). 5. Remove the fingerprint reader from the computer (5). Reverse this procedure to install the fingerprint reader board. Component replacement procedures 43
![](/manual_guide/products/hewlettpackard-zbook-studio-g3-maintenance-service-guide-ad621ee/57.png)