HP mt20 Maintenance and Service Guide - Page 40
sleeves must be installed on the antenna connectors, as shown in the following illustration.
View all HP mt20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
3. Remove the WLAN module (3) by pulling the module away from the slot at an angle. NOTE: WLAN modules are designed with a notch to prevent incorrect insertion. NOTE: If the WLAN antennas are not connected to the terminals on the WLAN module, the protective sleeves must be installed on the antenna connectors, as shown in the following illustration. Reverse this procedure to install the WLAN module. 30 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
3.
Remove the WLAN module
(3)
by pulling the module away from the slot at an angle.
NOTE:
WLAN modules are designed with a notch to prevent incorrect insertion.
NOTE:
If the WLAN antennas are not connected to the terminals on the WLAN module, the protective
sleeves must be installed on the antenna connectors, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
30
Chapter 5
Removal and replacement procedures for Customer Self-Repair parts