Hoover UH70102 Owners Manual - Page 9

Filter, assembly

Get Hoover UH70102 PDF manuals and user guides View all Hoover UH70102 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

Filter assembly How to clean filter assembly Remove dirt cup and dirt cup lid as described in "How to empty dirt cup". Pivot pre-filter assembly toward center of cup. Pull up on pre-filter assembly. Slide it out of cup. Remove pleated filter from pre-filter assembly. The screen (C) can be cleaned with a soft brush or rinsed with water. Do not rinse or wash the pleated filter. Bend filter to open pleats. Tap edges of filter until dust particles stop falling from filter. Do not tap the soft, pleated part of the filter. It could damage the filter. Lay filter on top of pre-filter. Make sure all filter pleats are inside the edges of the pre-filter. Press on filter gasket (F) until 4 tabs (G) (2 on either side of filter) are set in the slots (H) on the pre-filter. Be careful not to press the filter gasket below the pre-filter edge. I Slide pre-filter assembly all the way to bottom of cup. Pivot pre-filter assembly and snap in place. Replace dirt cup lid. If lid will not close completely, the pre-filter assembly is not positioned correctly. Replace dirt cup.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
Filter
assembly
How
to
clean
filter
assembly
Remove
dirt cup and dirt cup
lid as
described
in "How to empty
dirt cup".
Pivot pre-filter
assembly
toward
center of
cup.
Pull up on pre-filter
assembly.
Slide it out
of cup.
Remove pleated
filter from pre-filter
assembly.
The screen
(C) can be cleaned
with a
soft brush
or rinsed with water.
Do
not
rinse
or
wash
the
pleated
filter.
Bend filter to open pleats.
Tap edges
of filter until dust particles
stop falling from filter.
Do
not
tap the soft,
pleated
part of
the
filter. It could damage the filter.
Lay filter on top of pre-filter. Make sure
all filter pleats are inside the edges
of
the pre-filter.
Press on filter gasket
(F)
until 4 tabs
(G) (2 on either
side of filter)
are set in the slots (H) on the pre-filter.
Be careful
not to press the filter gasket
below the pre-filter
edge.
I
Slide pre-filter assembly
all the way to
bottom of cup.
Pivot pre-filter
assembly
and snap in
place.
Replace
dirt cup lid.
If
lid will
not close
completely,
the
pre-filter
assembly
is
not
positioned
correctly.
Replace
dirt cup.