IBM 86481BU Installation Guide - Page 28
Removing, bezel, installing, support, bracket
View all IBM 86481BU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Removing the bezel When working with some devices, such as additional optical drives, you must first remove the bezel to access the device. Complete the following steps to remove the bezel: 1. Unlock the side-cover lock. 2. Remove the side cover (see "Removing the side cover" on page 13). 3. For hot-swap hard disk drive models, slide the lock bar to the left. 4. Press the bezel-release lever toward the front of the server. 5. Remove the bezel from the server and store the bezel in a safe place. For instructions for replacing the bezel, see "Replacing the bezel" on page 39. Removing and installing the support bracket When working with some devices, such as hard disk drives, adapters, and memory modules, you must first remove the support bracket to access the device. Complete the following steps to remove the support bracket: 1. Read the safety information beginning on page vii and "Installation guidelines" on page 11. 2. Remove the side cover (see "Removing the side cover" on page 13). 3. Pull out on the rear end of the support bracket at a 45° angle. 4. Disengage the front end of the support bracket from the server and set the bracket aside. 14 xSeries 226 Type 8648: Installation Guide