IBM 86481BU Installation Guide - Page 42
components
View all IBM 86481BU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
v Terminator cards are not required for empty microprocessor sockets. However, for airflow, an empty microprocessor socket must contain a microprocessor baffle. v The microprocessor speeds are automatically set for this server; therefore, you do not have to set any microprocessor frequency-selection jumpers or switches. v If you must replace a microprocessor, call for service. v For additional illustrations of the system-board components, see "System-board option connectors" on page 7. The following illustration shows how to install an additional microprocessor. DIMMs Heat-sink release levers Microprocessor 2 Heat sink 2 VRM Microprocessor baffle assembly Microprocessor air baffle Complete the following steps to install a microprocessor: 1. Read the safety information beginning on page vii and "Installation guidelines" on page 11. 2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables. 3. Remove the side cover. See "Removing the side cover" on page 13. 4. Remove the support bracket. See "Removing and installing the support bracket" on page 14 5. Open the microprocessor air baffle. 28 xSeries 226 Type 8648: Installation Guide