IBM 86481BU Installation Guide - Page 66
Using, SCSISelect, Utility, program
View all IBM 86481BU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
4. Press Esc to exit the program. Using the SCSISelect Utility program (for SCSI RAID) Use the SCSISelect Utility program to add RAID level-0 and level-1 functionality to the SCSI controller. This utility is part of the BIOS code in your server. The integrated SCSI RAID feature (SCSI HostRAID) comes disabled by default. You must enable it and install the device drivers before you can use it. The SCSI RAID configuration utilities, device drivers, and information are available on the IBM ServeRAID-7e (Adaptec HostRAID) Support CD. If this CD did not come with your server, you can download it from http://www.ibm.com/pc/support/. Enabling the SCSI HostRAID feature Complete the following steps to enable the SCSI RAID feature: 1. Turn on the server. 2. When the message Press for SCSISelect Utility appears, press Ctrl+A. If you have set a supervisor password, you are prompted to type the password. 3. Use the arrow keys to select the channel for which you want to change settings, and press Enter. 4. Select Configure/View SCSI Controller Setting; then, select HostRAID. 5. Select Enabled. 6. Press Esc; then, select Yes to save the changes. Using the SCSI HostRAID feature The instructions in this section describe how to access the SCSI RAID feature from the SCSISelect Utility program and perform an initial RAID level-1 configuration. If you install a different type of RAID adapter, use the configuration method described in the instructions that come with that adapter to view or change SCSI settings for attached devices. See the documentation on the IBM ServeRAID-7e (Adaptec HostRAID) Support CD for additional information about how to use the SCSI HostRAID feature. Configuring the controller: Complete the following steps to use the SCSI HostRAID feature to configure a RAID level-1 array: 1. From the SCSISelect main menu, select Configure/View HostRAID Settings. 2. From the list of ready drives, type C to create an array. 3. When asked to select the RAID type, select RAID-1. 4. From the list of ready drives, select the two drives that you want to group into the array. 5. Select Create new RAID-1. 6. Type an identifier for the array. 7. Select Yes to create the array. 8. Press Esc to exit the utility. 9. Restart the server. Viewing the configuration: You can use the SCSISelect Utility program to view information about the SCSI controller. From the list of available arrays, select an array and press Enter. Press Esc to exit the utility. 52 xSeries 226 Type 8648: Installation Guide