IBM 86803RU Hardware Maintenance Manual - Page 101
Changing Jumper Positions, Two-Pin Jumper Blocks
![]() |
UPC - 087944453369
View all IBM 86803RU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Changing Jumper Positions Jumpers located on the I/O function card and processor board help you to customize the way your server operates. Your I/O function card and processor board contain two-pin and three-pin jumper blocks. In some cases, groups of jumpers might combine to define a function. Before you begin: Read "Safety Information" on page 226. To change a jumper position: 1. Remove the server top cover or front access cover, depending on the location of the jumper (see "Preparing to Install Options" on page 160). 2. If the jumper is located on the I/O function card, remove the I/O function card from the server: a. Refer to the following illustration while you perform the steps in this procedure. b. Disconnect the cables 1 from the I/O function card 2 . Note carefully where each cable is connected before you remove it. c. Remove the two screws 4 located on the metal connector plate inside the server. d. Carefully grasp the I/O function card by its top edge and pull the I/O function card out of the server. e. Place the I/O function card connector-side up on a flat, static-protective surface. 3. Locate the jumper: To change a two-pin jumper block, go to "Two-Pin Jumper Blocks" on page 94. Netfinity 7000-M10 - Type 8680 93
![](/manual_guide/products/ibm-86803ru-hardware-maintenance-manual-dc70288/101.png)