IBM 86803RU Hardware Maintenance Manual - Page 125
To add a power supply, open position, and slide the power supply into
UPC - 087944453369
View all IBM 86803RU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
To add a power supply: Note It is not necessary to turn the Power switch on the power supply off when you are installing a hot-swap power supply. 1. Remove the filler panel 2 : a. Remove the screws 1 from the filler panel. b. Remove the filler panel from the power-supply bay and save it and the screws for future use. Note During normal operation, be sure that each power-supply bay has either a power supply or filler panel installed for proper cooling. 2. Remove any shipping screws from the power supply. Note You do not need to replace the shipping screws. 3. Place the handle 4 on the power supply 3 in the open position, and slide the power supply into the chassis. 4. Close the handle on the power supply to seat the power supply in the bay. 5. Make sure the Power switch on the power supply is in the On position. 6. Verify that the DC Power light and AC Power light on the power supply are lit, indicating that the power supply is operating correctly. Netfinity 7000-M10 - Type 8680 117