IBM 86803RU Hardware Maintenance Manual - Page 163
in VRM sockets 3a and 3b., Install the VRMs for a third microprocessor
UPC - 087944453369
View all IBM 86803RU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
d. Remove the bracket from the server. 4. Determine the microprocessor socket in which you want to install the new microprocessor. Note Your server comes with a microprocessor installed in socket 1. Install a second microprocessor in socket 2, a third microprocessor in socket 3, and a fourth microprocessor in socket 4. 5. If you are adding a fourth microprocessor, remove the microprocessor terminator card 8 : Note To maintain signal quality and system reliability, a microprocessor or the microprocessor terminator card must be installed in microprocessor socket 4. a. Pull the microprocessor terminator card latches so they rotate to a 90-degree angle from the microprocessor terminator card. b. Grasp the two latches and carefully pull the microprocessor terminator card from the server. c. Store the microprocessor terminator card in a safe place. 6. Install the two voltage regulator modules (VRM) 6 included in the microprocessor kit. a. Refer to the label in front of the processor board inside the server for the location of the VRM sockets. Note Install the VRMs for a second microprocessor in VRM sockets 2a and 2b. Install the VRMs for a third microprocessor in VRM sockets 3a and 3b. Install the VRMs for a fourth microprocessor in VRM sockets 4a and 4b. b. Lift on the VRM retention bracket 5 to detach the bracket from the chassis. c. Carefully remove the bracket from the server. d. Install the VRMs in the VRM sockets. e. Install the VRM retention bracket. Note When correctly installed, the bracket holds the VRMs securely in place and does not move or shift. 7. Install the microprocessor: a. Touch the static-protective package containing the new microprocessor to any unpainted metal Netfinity 7000-M10 - Type 8680 155