IBM 86803RU Hardware Maintenance Manual - Page 103
Three-Pin Jumper Blocks, center pin and the pin that was not covered
UPC - 087944453369
View all IBM 86803RU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
2. If you removed the I/O function card, install it: a. Refer to the illustration in step 2a on page 93 while you perform the steps in this procedure. b. Carefully grasp the I/O function card by its top edge, and insert the tabs 3 on the bottom edge of the metal connector plate into the matching openings on the server back panel. c. Align the I/O function card with the guide on the opposite end of the adapter and the slot on the I/O board. d. Press the I/O function card firmly into the slot. Attention: When you install the I/O function card in the server, be sure that it is completely and correctly seated. Incomplete insertion might cause damage to server components. e. Insert the two screws you removed in step 2c on page 93. f. Connect the cables you disconnected in step 2b on page 93. 3. Reinstall the server top cover or front access cover and connect the cables (see "Completing the Installation" on page 97). Three-Pin Jumper Blocks: With the three-pin jumper blocks, each jumper covers two of the three pins on a pin block. You can position the jumper to fit over the center pin and either of the other two pins. The following illustration identifies pins 1, 2, and 3 on a three-pin jumper block: 32 1 To change the jumper position on a three-pin jumper block: 1. Lift the jumper straight off the pin block. 2. Align the holes in the bottom of the jumper with the center pin and the pin that was not covered previously. Netfinity 7000-M10 - Type 8680 95