IBM 86803RU Hardware Maintenance Manual - Page 138
Installing the Server in the Rack, Release the pressure on the sides of the handle.
UPC - 087944453369
View all IBM 86803RU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
Installing the Server in the Rack: In this section, you will use eight screws (M4 by 8 mm) and four screws (M6 by 16 mm). To install the server in the rack: 1. Fully extend the slide-bracket assemblies until they lock. 2. Install the four lift handles on the sides of the server. a. Press in on the sides of the lift handle near the tabs and insert the handle tabs into the slots on the sides of the server. b. Move the handle up in the slots so that the hooked part of each tab is inside the server. Release the pressure on the sides of the handle. c. Install the remaining three lift handles. 32 kg (70.5 lbs) 55 kg (121.2 lbs) Caution Use safe lifting practices when lifting your machine. 3. Lift and position the server so that the bayonet slots on the server are above the bayonets on the slide-bracket assemblies. 4. Lower the server and slip the bayonets into the bayonet slots. 130 Netfinity Server HMM