IBM 86803RU Hardware Maintenance Manual - Page 142

Removing the Server from a Rack Before you begin Read "Safety Information" on page 226. Turn off the server. Follow any additional installation and safety instructions that come with the rack. To remove the server from a rack: 1. If you have a modem or fax machine attached to the server, disconnect the telephone line from the electrical outlet and the server. Note If you are in the United Kingdom, you must perform this step before disconnecting the power cord. 2. Disconnect all cables and power cords from the rear of the server. 3. Disconnect all power cords from the rack. 4. Remove the screws from the bezel brackets on each side of the front bezel. Set them aside for later use. 5. Slide the server about halfway out of the rack. 6. Loosen the captive screws that secure the cable-management arm. 7. Fully extend the slide-bracket assemblies until they lock. 8. Remove the screws that attach the server to each slide-bracket assembly. 32 kg (70.5 lbs) 55 kg (121.2 lbs) Caution Use safe lifting practices when lifting your machine. 9. Install the four lift handles on the sides of the server. a. Press in on the sides of the lift handle near the tabs and insert the handle tabs into the slots on the sides of the server. b. Move the handle up in the slots so that the hooked part of each tab is inside the server. Release the pressure on the sides of the handle. c. Install the remaining three lift handles. 134 Netfinity Server HMM