IBM 86807RY Hardware Maintenance Manual - Page 127
Verify that the AC Power light and DC Power, To remove a hot-swap power supply, Attention
![]() |
UPC - 087944491972
View all IBM 86807RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
To remove a hot-swap power supply: 1. If your server has only two functioning power supplies and requires both (see "Hot-Swap Power Supply Installation" on page 115), turn off the server and peripheral devices (see "Preparing to Install Options" on page 160); otherwise, go to the next step. Attention Before removing a functional power supply, set the Power switch on the power supply to the Off position. 2. Set the Power switch on the power supply that you are removing to the Off position. 3. Remove the power supply: a. Remove any shipping screws from the power supply. Note You do not need to replace the shipping screws. b. Pull the handle on the power supply; then, slide the power supply out of the chassis. Note During normal operation, be sure that each power-supply bay has either a power supply or filler panel installed for proper cooling. 4. If you are not installing a replacement power supply, install a power-supply filler panel 2 ; then go to step 5. If you are replacing the power supply: a. Place the handle 4 on the power supply in the open position, and slide the power supply into the chassis. b. Close the handle on the power supply to seat the power supply in the bay. c. Make sure the Power switch on the power supply is in the On position. d. Verify that the AC Power light and DC Power light are lit, indicating that the power supply is operating correctly. 5. If you have other options to install or remove, do so now; otherwise, go to "Completing the Installation" on page 97. Netfinity 7000-M10 - Type 8680 119
![](/manual_guide/products/ibm-86803ru-hardware-maintenance-manual-dc70288/127.png)