IBM 86807RY Hardware Maintenance Manual - Page 139
secures the server., When the drawer is fully extended, safety latches
![]() |
UPC - 087944491972
View all IBM 86807RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
5. Remove the four lift handles from the sides of the server: a. Grasp the lift handle and press in on the sides of the lift handle near the tabs until the tabs touch the inside edges of the slots. b. Move the handle down in the slots so that the hooked parts of the tabs clear the top edges of the slots; then, pull the handle away from the server. c. Remove the remaining three handles. Store the handles in a safe place. 6. Insert four screws (M4 by 8 mm) through one slide-bracket assembly and server side. Tighten the screws. Repeat this step for the other slide-bracket assembly on the opposite side of the server. This secures the server. Note When the drawer is fully extended, safety latches on the slide-brackets lock into place. To release the safety latch, press the latch on each side of the rack. 7. Press the safety latches and slide the drawer about halfway into the rack. 8. Attach the cable-management arm to the server using the captive screws. Netfinity 7000-M10 - Type 8680 131
![](/manual_guide/products/ibm-86803ru-hardware-maintenance-manual-dc70288/139.png)