IBM 86807RY Hardware Maintenance Manual - Page 162
to a 90-degree angle from the memory board., Grasp the two latches and carefully pull
UPC - 087944491972
View all IBM 86807RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 162 highlights
Refer to the following illustration while you perform the steps in this section. ... ... 1 Memory board latches 2 Optional microprocessor 3 Latches 4 Microprocessor retention bracket 5 VRM retention bracket 6 VRMs for optional microprocessor 7 Guides 8 Microprocessor terminator card 9 VRMs for installed microprocessor 1 Installed microprocessor To install an additional microprocessor kit: 1. Run the shutdown procedure for the operating system. Turn off the server and peripheral devices and disconnect all external cables and power cords (see "Preparing to Install Options" on page 160); then remove the front bezel (see "Removing the Front Bezel" on page 163), and the front access cover (see "Removing the Front Access Cover" on page 163). 2. Remove the memory board from memory board socket 1: a. Pull the memory board latches 1 so they rotate to a 90-degree angle from the memory board. b. Grasp the two latches and carefully pull the memory board from the server. c. Put the memory board aside on a flat, static-protective surface. 3. Remove the microprocessor retention bracket 4 : a. Remove the shipping screw from the microprocessor retention bracket. b. Grasp the bracket handle and pull downwards firmly to detach the bracket from the server. c. Pivot the bracket to a 90-degree angle from the processor board. 154 Netfinity Server HMM