IBM 8852 User Guide - Page 37
Removing a blade server, Removing a management module
![]() |
UPC - 883436027069
View all IBM 8852 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Removing a blade server Attention: Note the bay number. Reinstalling a blade server into a different bay than the one from which it was removed could have unintended consequences. Some configuration information and update options are established according to bay number. To remove a blade server, complete the following steps. Release handles (open) 1. Read the safety information that begins on page v and "Installation guidelines" on page 18. 2. Move the two release handles to the open position. The blade server moves out of the bay approximately 0.6 cm (0.25 inch). 3. Pull the blade server out of the bay. Removing a management module To remove a management module or filler, complete the following steps. Module filler Management module Release handle (open) 1. Read the safety information that begins on page v and "Installation guidelines" on page 18. 2. Pull the module release handle to the open position. The module moves out of the bay approximately 0.6 cm (0.25 inch). 3. Slide the module out of the bay. Chapter 3. Installing the BladeCenter unit and options 21
![](/manual_guide/products/ibm-8852-user-guide-b2a9014/37.png)