IBM 88743RU User Guide - Page 73
Configuration/Setup
UPC - 000435945938
View all IBM 88743RU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
- Baseboard management controller (BMC) settings Select this choice to view information and to change baseboard management controller (BMC) settings. - BMC firmware Ver This is a nonselectable menu item that displays the BMC firmware version. - BMC POST Watchdog Enable or disable the BMC POST watchdog. Disable is the default setting. - BMC POST Watchdog Timeout Set the BMC POST watchdog timeout value. 5 minutes is the default setting. - System BMC Serial Port Sharing Enable or disable the system BMC serial port sharing. Enable is the default setting. - BMC Serial Port Access Mode Share or disable the BMC serial port access mode. Shared is the default setting. - Reboot system on NMI If you enable this option, the server automatically restarts 60 seconds after the service processor issues a nonmaskable interrupt (NMI) to the server. If you disable this option, the server does not restart. Enable is the default setting. - BMC Network Configuration Select this choice to view the BMC Network Configuration information. - BMC System Event Log Select this choice to view the BMC system event log, which contains all system error and warning messages that have been generated. Use the arrow keys to move between pages in the log. If an optional IBM Remote Supervisor Adapter II SlimLine is installed, the full text of the error messages is displayed; otherwise, the log contains only numeric error codes. Run the diagnostic program to get more information about error codes that occur. See the Problem Determination and Service Guide on the IBM System x Documentation CD for instructions. Select Clear error logs to clear the BMC system event log. v Error Logs Select this choice to view or clear error logs. This choice is available on the full Configuration/Setup Utility menu only. - POST Error Log Select this choice to view the three most recent error codes and messages that were generated during POST. Select Clear error logs to clear the POST error log. v Save Settings Select this choice to save the changes that you have made in the settings. v Restore Settings Select this choice to cancel the changes that you have made in the settings and restore the previous settings. v Load Default Settings Select this choice to cancel the changes you have made in the settings and restore the factory settings. v Exit Setup Chapter 3. Configuring the server 61