IBM E02HRLL-G Administration Guide - Page 179
Fixing BCG210013 error
![]() |
View all IBM E02HRLL-G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 179 highlights
The Content-Types attribute can be set by the following steps: 1. Go to Hub Admin > Hub Configuration > Fixed Workflow > InBound. 2. Click com.ibm.bcg.server.ChannelParseFactory. 3. Click Edit. 4. In the configured list, select EDIRouterBizProcessHandler and click Configure. 5. Edit Content-Types attribute by adding text/plain content type. This applies the EDI handler and the document gets processed as EDI. These content types value should be separated by a comma. The Content-Types attribute is used for a particular set of handlers. These handlers are v BinaryChannelParseHandler v XMLRouterBizHandler v EDIRouterBizProcessHandler v cXMLChannelParseHandler These handlers are populated with a default list of content types. To modify the content types, perform the following steps: 1. Go to Hub Admin > Hub Configuration > Fixed Workflow > InBound. 2. Click com.ibm.bcg.server.ChannelParseFactory. 3. Click Edit. 4. In the configured list, select the handler and click Configure. 5. Edit the Content-Types attribute by adding the new content type. Ensure that the content-type values are separated by a comma. Note: It is recommended not to change these content-type values unless advised. Fixing BCG210013 error About this task Unable to receive inbound document because of the following error: BCG210013 - Connection Not Fully Configured If all other configurations appear to be correct, the most common cause of this is an incorrect receiver specification. 1. Check that there are no spaces in front of the receiver URL definitions. 2. Try to narrow down the problem trying to send a test EDI message using other business IDs available for the partners. Try to see if this is a business ID specific problem. 3. If the previous step fails, then take a debug trace of the error scenario as follows: a. Shut down WebSphere Partner Gateway. b. Change the debug setting for the receiver and router to FINEST for WebSphere Partner Gateways using the following command: "*=info:com.ibm.bcg.*=finest" c. Delete (or backup to a different folder), the current logs in these directories: v In simple mode installation, the logs are located in the following directory: Chapter 17. Troubleshooting 173
![](/manual_guide/products/ibm-e02hrllg-administration-guide-f948001/179.png)