IBM E02HRLL-G Administration Guide - Page 29
Deleting receivers, Localizing HTTP synchronous target time out, Managing interactions and document
View all IBM E02HRLL-G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
3. Click Edit icon to edit the receiver parameters. 4. In the Status field, select either Enabled or Disabled option to change the receiver status. Deleting receivers About this task You can delete receivers that you are not going to use. Note that the deletion occurs immediately. There is no warning message asking you to confirm this step. 1. Click Hub Admin > Hub Configuration > Receivers. Note: The receiver in the following step is immediately deleted without a warning message. Be sure that you want to delete the receiver. 2. On the Receiver List window, click the Delete icon next to the receiver you want to delete. Localizing HTTP synchronous target time out About this task WebSphere Partner Gateway allows you to have a localized synchronous time out and synchronous connection values for every HTTP Receiver. The synchronous connection value cannot exceed the container allowed TCP connection limit. The maximum synchronous connection per receiver alone is controlled in the super set of container limit. Web container (WebSphere Application Server) is configured separately through managed application to allow or limit the number of HTTP connections. To modify the values of Max sync time out and Max sync connection: 1. Navigate to Receiver creation page > Hubadmin > Receivers. 2. Click Edit icon corresponding to the HTTP receiver. 3. Modify the values of Max sync time out and Max sync connection. Note: Max sync time out does not accept negative values. Entering the value zero for Max synchronous connection removes the restriction of Max sync connection over any receiver. Managing interactions and document definitions About this task To enable, disable, or edit interactions between two document definitions, follow these steps: 1. Click Hub Admin > Hub Configuration > Document Definition. 2. Click Manage Interactions. 3. Enter the search criteria that WebSphere Partner Gateway will use to find the interaction you want to enable, disable, or edit. 4. Click Search. The system finds all interactions that meet your search criteria. 5. To enable an interaction, click the Activate icon next to the interaction you want to enable. Click OK to confirm. WebSphere Partner Gateway replaces the Activate icon with the Deactivate icon. This indicates that the interaction is enabled. Chapter 4. Hub administration tasks 23