Icom IC-A210 Instruction Manual - Page 14

3 MEMORY OPERATION I Channel selection The transceiver has 10 regular memory and 200 group channels (10 channels × 1 REGULAR MEMORY and 10 channels × 20 GROUPS) for storage of often-used frequencies along with 6-character notes. q Push [RCL] to enter the memory mode. • The channel number appears. • The memory channel name also appears if it has been entered. w Rotate [O-DIAL] to select the memory channel type. • Select from regular memory channel or group memory channel. e Rotate [DIAL] to select the desired memory channel number. RX MEMORY 122.00 127.005 CH01 Transferring the memory channel to the active frequency is necessary if operating at the memory channel. Refer to "Transferring memory contents" (p. 12) for details. r Push [RCL] to exit the memory mode. I Programming a memory channel This transceiver is equipped with 10 regular memory and 200 group channels. You can program often-used frequencies into them. q Rotate [DIAL] and [O-DIAL] to set the desired frequency for the standby frequency indicator. w Push [RCL] to enter the memory mode. • The channel number appears. • The memory channel name also appears if it has been entered. e Rotate [O-DIAL] to select the desired memory channel type. • Select regular memory channel or group memory channel. r Push [MEM] again, and then rotate [O-DIAL] to select a "REPLACE" menu. • The memory channel number blinks. t Rotate [DIAL] to select a memory channel to be programmed. y Push [MEM], then the selected memory channel is programmed. • "WRITE COMPLETED" appears on the display when the regular memory channel is programmed. u Push [RCL] to exit the memory mode. 10