Icom IC-V3500 Advanced Manual - Page 13
Reversed Duplex function, Auto Repeater function, Setting the Auto Repeater function ON/OFF
View all Icom IC-V3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
2. REPEATER OPERATION Reversed Duplex function When the Reversed Duplex function is ON, the receive frequency shifts. (The transmit frequency shifts in normal Duplex mode.) An example receive and transmit frequency are shown in the table below with the following settings: Input frequency: 145.30 MHz Offset direction: - (Negative) Offset frequency: 0.6 MHz Function RX frequency TX frequency OFF 145.30 MHz 144.70 MHz ON 144.70 MHz 145.30 MHz 1. Push [SET LOCK] to enter the Set mode. 2. Repeatedly push [SET LOCK] or [MONI ANM PA] to select "REV" (Reverse mode). 3. Rotate [DIAL] to turn the function ON or OFF. 4. Push any key other than [SET LOCK] or [MONI ANM PA] to save and exit the Set mode. Using the HM-133V 1. Push [SET B D-OFF] to enter the Set mode. 2. Repeatedly push [SET B D-OFF] or [ENT C T-OFF] to select "REV." 3. Push [▲] or [▼] to turn the function ON or OFF. 4. Push [CLR A MW] to save and exit the Set mode. MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY The Reversed mode item MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz The duplex icon blinks when the function is ON. Auto Repeater function NOTE: This function is only for the USA version. The USA version automatically activates the repeater settings (DUP- or DUP+ and tone encoder ON/OFF) when the operating frequency falls within the general repeater output frequency range and deactivates them when outside of the range. DDSetting the Auto Repeater function ON/OFF 1. Push [ ] to turn OFF the transceiver. 2. While holding down [SET LOCK], hold down [ ] for 1 second to enter the Initial Set mode. 3. Repeatedly push [SET LOCK] or [MONI ANM PA] to select "RPT" (Auto Repeater). 4. Rotate [DIAL] to select an option from "R1," "R2," or "OF." •• "OF": The function is OFF. •• "R1": The function is ON, but the tone encoder is OFF. •• "R2": Both the function and tone encoder are ON. 5. Push [ ] to exit the Initial Set mode. DDFrequency range and offset direction Frequency range 145.200 ~ 145.495 MHz 146.610 ~ 146.995 MHz 147.000 ~ 147.395 MHz Duplex direction A "-" is displayed. A "-" is displayed. A "+" is displayed. MUTE NAR MID LOW LOCK SET ANM MONI DUP LOW DIGITAL PRIO AO BUSY T-SCAN TONE PRIO M/CALL SCAN V/ MHz MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz The Auto Repeater item 2-5