Icom IC-V3500 Advanced Manual - Page 77

9. OTHER FUNCTIONS Resetting Occasionally, erroneous information will be displayed when, for example, first applying power. This may be caused externally by static electricity or by other factors. If this problem occurs, turn OFF the transceiver. After waiting a few seconds, turn ON the transceiver again. If the problem is still there, perform a Partial reset or an All reset. BE CAREFUL! An All Reset clears all settings and returns all settings to the factory defaults. DDPartial Reset 1. Hold down [ ] for 1 second to turn OFF the transceiver. 2. While holding down [V/MHz SCAN], hold down [ ] for 1 second to turn ON the transceiver. TIP: A Partial Reset resets the operating settings to their default values (VFO frequency, VFO settings, the Set mode, the Initial Set mode, and the Option Set mode contents) without clearing the items below: •• Memory channel contents •• Scan Edge channel contents •• Call channel contents •• DTMF Memory contents [] [V/MHz SCAN] MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz DDAll Reset 1. Hold down [ ] for 1 second to turn OFF the transceiver. 2. While holding down [SET LOCK] and [S.MW MW], hold down [ ] for 1 second to turn ON the transceiver. ••"CLEAR" is displayed. [] [SET LOCK] [S.MW MW] MUTE NAR MID LOW DIGITAL PRIO AO BUSY MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz 9-5