Icom IC-V3500 Advanced Manual - Page 79

10. PROGRAMMING Programming operation The transceiver has a data copying capability. This function is useful for copying all of the settings and entered contents from one transceiver to another. You can also program data from a PC to a transceiver, using the optional CS-V3500 programming software. DDCloning between two transceivers An optional OPC-474 programming cable is required. 1. Connect the master and sub-transceivers using the OPC-474 through their [SP] jacks. ••The master transceiver is used to send data to the sub-transceiver. 2. Turn ON the sub-transceiver. 3. While holding down [M/CALL PRIO], hold down [ ] for 1 second to turn ON the master transceiver and enter the Cloning mode. ••"CLONE" is displayed. 4. Push [S.MW MW] on the master transceiver to start cloning. ••"CL OUT" is displayed on the master transceiver's display, and the S/RF meter shows that data is being transferred to the sub-transceiver. ••"CL IN" is displayed on the sub-transceiver's display, and the S/RF meter shows that data is being received from the master transceiver. ••When the cloning is finished, the master transceiver returns to the cloning mode screen, and the subtransceiver displays "CL OK." 5. Turn OFF both transceivers, and then turn ON the transceivers again to exit the cloning mode. NOTE: DO NOT push any key on the subtransceiver while cloning. This will cause an error. When "CL NG" is displayed, a cloning error has occurred. In this case, follow the cloning procedures again. MUTE NAR MID LOW LOCK ANM PRIO AO Cloning error To the [SP] jack To the [SP] jack OPC-474 The master transceiver While holding down [M/CALL PRIO], turn ON the transceiver. [] MUTE NAR MID LOW LOCK ANM [M/CALL PRIO] PRIO AO During cloning mode Push [S.MW MW] to start cloning. [S.MW MW] MUTE NAR MID LOW LOCK ANM PRIO AO The sub-transceiver MUTE NAR MID LOW LOCK ANM PRIO AO MUTE NAR MID LOW LOCK ANM 10-2 PRIO AO While cloning While cloning The cloning is completed.