Icom IC-V3500 Advanced Manual - Page 64
DTCS encoder (Transmit only), is displayed when the DTCS encoder is
![]() |
View all Icom IC-V3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
7. TONE SQUELCH AND POCKET BEEP DTCS encoder (Transmit only) The DTCS encoder superimposes the selected DTCS code over your transmitted signal. 1. Repeatedly push [TONE T-SCAN] until both " " and " " are displayed. ••The DTCS encoder is activated. 2. Push [SET LOCK] to enter the Set mode. 3. Set the DTCS code and polarity. LLSee page 7-2 for details. LLYou can set the DTCS transmit and receive polarity, but the DTCS encoder affects only transmit. 4. Push any key other than [SET LOCK] or [MONI ANM PA] to save and exit the Set mode. MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz " " and " " is displayed when the DTCS encoder is activated. 7-8
![](/manual_guide/products/icom-icv3500-advanced-manual-63f83c3/64.png)
7-8
7.
TONE SQUELCH AND POCKET BEEP
The DTCS encoder superimposes the selected DTCS code over your transmitted signal±
DTCS encoder (Transmit only)
LOCK
S
E
T
ANM
MONI
DUP
LOW
T-SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
“
” and “
” is displayed when the DTCS encoder is
activated±
1±
Repeatedly push [TONE T-SCAN] until both “
”
and “
” are displayed±
• The DTCS encoder is activated±
2±
Push [SET LOCK] to enter the Set mode±
3±
Set the DTCS code and polarity±
L
See page 7-2 for details±
L
You can set the DTCS transmit and receive polarity,
but the DTCS encoder affects only transmit±
4±
Push any key other than [SET LOCK] or
[MONI ANM PA] to save and exit the Set mode±