Intel S1200BT Technical Product Specification - Page 117

Intel® Server Board S1200BT TPS Connector/Header Locations and Pin-outs Pin Signal Name Pin Signal Name 9 LED_HDD_ACT_N 10 LED_STS_AMBER_N 11 FP_PWR_BTN_N 12 LED_ NIC1_ACT 13 GND 14 LED_NIC1_LINK_N 15 FP_RST_BTN_N 16 SMB_SEN_3V3SB_DAT 17 GND 18 SMB_SEN_3V3SB_CLK 19 FP_ID_BTN_N 20 INTRUDER_HDR 21 PU_FM_SIO_TEMP_SENSOR 22 LED_ NIC2_ACT 23 FP_NMI_BTN_N 24 LED_ NIC2_LINK_N Combined system BIOS and the Integrated BMC support provide the functionality of the various supported control panel buttons and LEDs. The following sections describe the supported functionality of each control panel feature. Note: Control panel features are also routed through the bridge board connector at location J1C1 as is implemented in Intel® Server Systems configured using a bridge board and a hot- swap backplane. 7.4.1 Power Button The BIOS supports a front control panel power button. Pressing the power button initiates a request that the Integrated BMC forwards to the ACPI power state machines in the chipset. It is monitored by the Integrated BMC and does not directly control power on the power supply.  Power Button - Off to On The Integrated BMC monitors the power button and the wake-up event signals from the chipset. A transition from either source results in the Integrated BMC starting the powerup sequence. Since the processor are not executing, the BIOS does not participate in this sequence. The hardware receives the power good and reset signals from the Integrated BMC and then transitions to an ON state.  Power Button - On to Off (Operating system absent) The System Control Interrupt (SCI) is masked. The BIOS sets up the power button event to generate an SMI and checks the power button status bit in the ACPI hardware registers when an SMI occurs. If the status bit is set, the BIOS sets the ACPI power state of the machine in the chipset to the OFF state. The Integrated BMC monitors power state signals from the chipset and de-asserts PS_PWR_ON to the power supply. As a safety mechanism, if the BIOS fails to service the request, the Integrated BMC automatically powers off the system in four to five seconds.  Power Button - On to Off (Operating system present) If an ACPI operating system is running, pressing the power button switch generates a request using SCI to the operating system to shut down the system. The operating system retains control of the system and the operating system policy determines the sleep state into which the system transitions, if any. Otherwise, the BIOS turns off the system. 7.4.2 Reset Button The platform supports a front control panel reset button. Pressing the reset button initiates a request forwarded by the Integrated BMC to the chipset. The BIOS does not affect the behavior of the reset button. Revision 2.0 105 Intel order number G13326-004