Intermec CN50 CN50 Mobile Computer for Windows Embedded Handheld 6.5 User Manu - Page 22

Chapter 1 - About the Computer Features The battery used in this device may present a fire or chemical burn hazard if it is mistreated. Do not disassemble it, heat it above 100 °C (212 °F) or incinerate it. Dispose of used batteries promptly. Keep away from children. If you remove the battery pack before turning off the CN50, the CN50 goes into a power off state and then cold boots. To preserve your data, tap Start and then tap Shutdown to turn off the CN50 before removing the battery. Contact your Intermec representative for replacement batteries. Charge the Battery Make sure you fully charge the AB25 battery before you use your CN50. You can charge the battery before or after you install it in the CN50. A fully discharged battery charges in approximately 6 hours. Use the next table to understand how long it takes to charge your battery in each of the CN50 charger or dock accessories. Charging Times for CN50 Battery CN50 Charging Accessory AC21 quad battery charger AD23 charge-only multidock AD24 Ethernet multidock AD27 single dock charger AE36 vehicle power adapter AE37 AC adapter DX1, DX2, or DX4 dock AB25 Charging Time 6 hours 6 hours 6 hours 6 hours 6 hours 6 hours Up to 6 hours The battery is fully charged when the battery status LED shows a steady green. For information on these accessories, see "CN50 Accessories" on page 5. • Insert the battery into a quad battery charger, a single dock, or a multidock, or attach external power to the CN50 with the battery installed. 8 CN50 Mobile Computer for Windows Embedded Handheld 6.5 User Manual