Intermec PB50 PB50 and PB51 Mobile Printer User Guide - Page 52
Configuring Wireless Printing Using Fingerprint, To con the printer to use WEP authentication
![]() |
View all Intermec PB50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Chapter 2 - Configuring the Mobile Printer Configuring Wireless Printing Using Fingerprint Use the following procedures to configure your printer with Fingerprint for wireless printing. To configure the printer to use WEP authentication 1 Send the following commands to login as an administrator and set the SSID: run"su -p pass admin" setup write "wlan","uart1:" setup "wlan","SSID","xxxxx" where xxxxx can be from 0 to 32 ASCII characters, not including the double quote. Note: The default password for logging in as an admin is "pass." If you have changed the password, you will need to use your password instead of "pass." 2 Send the following commands to configure the WEP keys. The following example sets WEP key 1 to 1234 and enables WEP key 1. setup "wlan","WEP1","0x0001020304" setup "wlan",".WEP_KEY","1" setup "wlan","ACTIVE","1" setup write "wlan","uart1:" To configure the printer to use WPA-PSK or WPA2-PSK mode 1 Send the following commands to login as an administrator and set the SSID: run"su-p pass admin" setup write "wlan","uart1:" setup "wlan","SSID","xxxxx" where xxxxx can be from 0 to 32 alphanumeric characters. 2 Send one of the following WPA/WPA2 ON commands to turn on WPA or WPA2 authentication. Send the WPA-PSK or WPA2-PSK command to set a pre-shared key: setup "wlan","WPA","ON" setup "wlan","WPA2","ON" setup "wlan","WPA_PSK","xxxxxxxxxx" setup "wlan","ACTIVE","1" setup write "wlan","uart1:" where xxxxxxxxxx is a value between 8 and 64 characters. 40 PB50 and PB51 Mobile Printer User Guide
![](/manual_guide/products/intermec-pb50-pb50-pb51-mobile-printer-user-guide-cd04f20/52.png)