Intermec PB50 PB50 and PB51 Mobile Printer User Guide - Page 54
Configuring the Printer Settings, Changing Configuration Settings from the Control Panel - starting loop
View all Intermec PB50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Chapter 2 - Configuring the Mobile Printer • Send the following commands to set a common name for server 1 and server 2: setup "8021x",".SERVER_CN1","xxxxxxxxxx" setup "8021x",".SERVER_CN2","xxxxxxxxxx" where xxxxxxxxxx can be a value from 0 to 64 characters. • Send the following command to make sure your values match those used by the access point: setup write "8021x","uart1:" • You may need to send the following command several times for the wireless station to connect: setup "wlan","ACTIVE","1" Configuring the Printer Settings You can change the configuration settings of the printer from: • the Control Panel, or display. • the host PC using PrintSet. • the host PC using the command line. • the printer home page. • the SmartSystems Console. For more information on the IPL and Fingerprint menu systems, see "IPL Setup Menu" on page 80. Changing Configuration Settings from the Control Panel You need to start Setup mode before you can change configuration settings from the Control Panel or display. For more information on starting Setup mode and navigating through the settings, see "Understanding Setup Mode" on page 23. The top levels of the Setup menu are organized in a one-way loop. Each level has several sub-levels. Note: The Setup menu is not available when using ESC/P. 42 PB50 and PB51 Mobile Printer User Guide