Intermec PX4i Intermec Direct Protocol 8.60 Programmer's Reference Manual - Page 78
IPL Mode, Gap Truncate Mode
View all Intermec PX4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Chapter 5-Setting Up the Printer IPL Mode If the print image is longer than the physical length of the label or ticket, the print image will extend into the following label(s) until the entire print image has been printed. Then the media is fed out to the next gap or mark according to the stop adjust setup. This means that the print image will not be truncated but may extend into one or more consecutive labels, and some of the print image may coincide with gaps or slots. Gap Truncate Mode If the print image is longer than the physical length of the label or ticket, only the part of the print image that fits on the label or ticket will be printed and the remainder will be ignored. This means that some of the print image may not be printed at all, but the following labels will not be affected. 70 Intermec Direct Protocol v.8.60-Programmer's Reference Manual