Invacare 9XT Owners Manual - Page 45

5 FRONT RIGGINGS 5. Install new heel loop onto slide tube. 6. Install the mounting screw, spacer and locknut to secure the heel loop to the footplate. Tighten until the spacer is secure. 7. Insert the lower footrest assembly into the upper footrest assembly to desired height. 8. Perform one of the following as shown in Detail "A": • Footplates With Spring Buttons: Ensure that the release buttons fully protrude from holes on both sides of the upper footrest support. • Bolt-In-Place Footplates: i. From the outside of the swingaway front rigging, insert the threaded rivet through both the front rigging support and the footplate assembly. ii. From the inside of the swingaway front rigging, insert the button head screw through the appropriate adjustment hole and thread into the threaded rivet. iii. Using a screwdriver to hold the threaded rivet in position, securely tighten the button head screw. Torque to 32 in-lbs. 9. Rotate cam lock lever down to locked position. Footplates with Spring Buttons DETAIL "A" Bolt-in-Place Footplates Front Rigging Button Head Front Rigging Screw Support Support Threaded Rivet g Screw Cam Lock Lever Heel Loop Release Button Adjustment Holes Footplate Assembly Inside of Swingaway Front Rigging Cam Lock Lever  Swingaway footrest shown. Cam Lock Lever Outside of Swingaway Front Rigging Adjustment Hole Footplate Assembly Footplate Assembly FIGURE 6 Replacing Heel Loop Spacer Locknut Slide Tube Footplate Assembly Footplate Part No. 1056953 45 Invacare® 9000 Series Wheelchair