Invacare M41SR16R Owners Manual - Page 30

Wheelchair, Operation

Get Invacare M41SR16R PDF manuals and user guides View all Invacare M41SR16R manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

SECTION 6-WHEELCHAIR OPERATION SECTION 6-WHEELCHAIR OPERATION ƽ WARNING After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result. Set-up of the Electronics Control Unit is to be performed only by a qualified technician. The final adjustments of the controller may affect other activities of the wheelchair. Damage to the equipment could occur if improperly set-up or adjusted. Turning the Power On/Off NOTE: For this procedure, refer to FIGURE 6.1. 1. To turn the power On by pressing the On/Off button. NOTE: After turning power on, the battery gauge indicators will light briefly. One of the following will occur after that: • The current battery charge will be indicated on the information gauge display. Information Gauge Display On/Off Button • Lock Mode will be indicated by all LEDs flashing briefly and the information gauge LEDs chasing slowly from right to left. If this occurs, press the horn button two times within ten seconds to unlock the joystick. 2. Turning the power Off can be achieved by pressing the On/Off button. FIGURE 6.1 Turning the Power On/Off NOTE: If the joystick has been programmed for lock mode, holding the On/Off button down for four seconds will lock the joystick. The LEDs will flash briefly and the horn will sound a short beep. Pronto® M41 with SureStep® 30 Part No. 1143206

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
SECTION 6—WHEELCHAIR OPERATION
Pronto® M41 with SureStep®
30
Part No. 1143206
SECTION 6—WHEELCHAIR
OPERATION
±
WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Set-up of the Electronics Control Unit is to be performed only by a qualified techni-
cian. The final adjustments of the controller may affect other activities of the wheel-
chair. Damage to the equipment could occur if improperly set-up or adjusted.
Turning the Power On/Off
NOTE: For this procedure, refer to FIGURE 6.1.
1.
To turn the power On by pressing the
On/Off button.
NOTE: After turning power on, the battery
gauge indicators will light briefly. One of the
following will occur after that:
•
The current battery charge will be indicated
on the information gauge display.
•
Lock Mode will be indicated by all LEDs
flashing briefly and the information gauge
LEDs chasing slowly from right to left. If
this occurs, press the horn button two times
within ten seconds to unlock the joystick.
2.
Turning the power Off can be achieved
by pressing the On/Off button.
FIGURE 6.1
Turning the Power On/Off
NOTE: If the joystick has been programmed for lock mode, holding the On/Off button down for
four seconds will lock the joystick. The LEDs will flash briefly and the horn will sound a short beep.
On/Off
Button
Information
Gauge Display