Invacare M41SR16R Owners Manual - Page 66
Accessories
View all Invacare M41SR16R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
SECTION 14-ACCESSORIES SECTION 14-ACCESSORIES ƽ WARNING After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result. Before performing any maintenance, adjustment or service verify that on/off switch on the joystick is in the off position. Installing/Removing the Crutch/Cane Holder ƽ WARNING The installation of the crutch/cane holder onto the back of the seat significantly increases the length of the wheelchair. When turning the wheelchair or swiveling the wheelchair seat, it is important to take note of this increased length - otherwise, injury and/or damage to the surrounding property may result. NOTE: For this procedure, refer to FIGURE 14.1. NOTE: The Crutch/Cane Holder, Oxygen Holder, and Walker Holder all install into the accessory tube. Only one of these may be installed at a time. NOTE: To remove, reverse the following procedure. Installing 1. If necessary, loosen but do not remove the mounting knob. 2. Install the crutch/cane holder into the accessory tube located on the back of the seat. 3. Thread the mounting knob into the welded nut on the accessory tube. Securely tighten. 4. Align slot on base with hook on crutch/cane holder and slide base down into position. Seat Crutch/Cane Holder Accessory Tube Hook Base Mounting Knob FIGURE 14.1 Installing/Removing the Crutch/Cane Holder Pronto® M41 with SureStep® 66 Part No. 1143206