Invacare M41SR16R Owners Manual - Page 45
Front Riggings
View all Invacare M41SR16R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
SECTION 10-FRONT RIGGINGS SECTION 10-FRONT RIGGINGS ƽ WARNING After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result. While the wheelchair is moving, minimum ground clearance for the front rigging is three inches. If the wheelchair is not moving, the front rigging MUST maintain a minimum of one inch ground clearance - otherwise personal injury and damage may result. DO NOT stand on the front riggings, otherwise damage may occur. When getting in or out of the wheelchair, make sure that the footplates on the front riggings are in the upward position or moved out of the way. Before performing any maintenance, adjustment or service verify that On/Off switch on the joystick is in the Off position. Installing/Removing Front Riggings CAUTION If front riggings are used, then the seat MUST be adjusted to the highest mounting position - otherwise damage may occur. NOTE: For this procedure, refer to FIGURE 10.1. Installing 1. If necessary, remove the footboard. Refer to Removing/Installing the Footboard Assembly on page 41. 2. Turn front rigging to the side (open footplate is perpendicular to wheelchair) and position mounting holes in the front rigging hinge plates with hinge pins on the wheelchair frame. 3. Install the front rigging hinge plates onto the hinge pins on the wheelchair frame. 4. Push the front rigging towards the inside of the wheelchair until it locks into place. NOTE: The footplate will be on the inside of the wheelchair when locked in place. 5. Repeat STEPS 1‐4 for opposite side of wheelchair. Hinge Pins Telescoping Front Rigging Support Front Rigging Release Lever Front Rigging Hinge Plate FIGURE 10.1 Installing/Removing Front Riggings Part No. 1143206 45 Pronto® M41 with SureStep®