Invacare M41SR16R Owners Manual - Page 68
Installing/Removing/Using the Walker Holder
View all Invacare M41SR16R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
SECTION 14-ACCESSORIES Clamp Knob Protective Caps Welded Nut Upper Support Clamp Knob Lower Support Welded Nut Clamp Knob Mounting Tube Accessory Tube Mounting Nut Welded Nut Protective Caps NOTE: Seat not shown. Clamp Knob Mounting Bolt Mounting Hand Knob FIGURE 14.2 Installing/Removing the Oxygen Holder Installing/Removing/Using the Walker Holder ƽ INSTALLATION WARNINGS After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely. The installation of the walker holder onto the back of the wheelchair seat increases the length of the wheelchair up to nine inches. When turning the wheelchair it is important to take note of this increased length - otherwise, injury and/or damage to surrounding property may result. NOTE: For this procedure, refer to FIGURE 14.3 on page 69. Installing/Removing the Walker Holder NOTE: Reverse this procedure to remove the walker holder. NOTE: The Crutch/Cane Holder, Oxygen Holder, and Walker Holder all install into the accessory tube. Only one of these may be installed at a time. 1. If necessary, loosen but do not remove the mounting knob. 2. Install the walker holder into the accessory tube. 3. Thread the mounting knob into the welded nut on the accessory tube. Securely tighten. Pronto® M41 with SureStep® 68 Part No. 1143206