Kenmore 1317 Use and Care Guide - Page 18

To install double rear insert NOTE: It will be easier to install the inserts if you remove the silverware basket from the rack. 1. Place the double rear insert end legs under the 3rd wire from the right as shown below. IMPORTANT: Make sure that the curved wires, on the bottom of the insert, fit over the wires in the bottom of the rack. 2. Push down on insert until handle fits against outer rack edge. 3. When center tab under handle locks in under the middle side rack wire, the insert is in place. (See illustration.) To install single front insert 1. Place the single front insert end legs under the 2nd wire from the right as shown below. IMPORTANT: Make sure the 3 hooks at the back of the insert are installed over the 2nd bottom rack wire from the front of the rack. 2. Push down on insert until handle fits against outer rack edge. 3. When center tab under handle locks in under the middle side rack wire, the insert is in place. (See illustration.) Utensil caddy Use the utensil caddy to hold specialty cooking utensils (serving spoons, spatulas, and similar items), or overflow silverware items. The caddy hangs on the bottom rack in the right-hand corner. Load the caddy while it is on the bottom rack or remove the basket for loading on a counter or table. NOTE: Spin the spray arms. Be sure items in the caddy do not stop the rotation of the spray arms. 18 B A, 3 insert hooks B. Single front insert end legs