Kenmore 1317 Use and Care Guide - Page 21

Delay Hours, To delay the start, Front Panel Lights

Get Kenmore 1317 - Pro 24 in. Dishwasher PDF manuals and user guides
UPC - 883049058658
View all Kenmore 1317 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

Delay Hours Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak hours when possible. To delay the start 1. Select a wash cycle and options. 2. Press the delay button to choose the number of hours to be delayed. 3. Press START/RESUME and firmly close the door within 3 seconds. NOTE: Anytime the door is opened (such as, to add a dish), the START/RESUME button must be pressed again, within 3 seconds of closing the door, to resume the delay countdown. Control Lock Option Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When LOCK ON is lit, all buttons are disabled. The dishwasher door can still be opened/closed while the controls are locked. To turn on the Lock Press and hold HEATED DRY for 4 seconds. LOCK ON will light up. If you press any pad while your dishwasher is locked, the light flashes 4 times. NOTE: The dishwasher cannot run if the control is locked. To turn off the Lock Press and hold HEATED DRY for 4 seconds. The light turns off. Status Indicator Lights ABC Front Panel Lights - The left light indicates the dishwasher is in the wash cycle. The middle light indicates the dishwasher is in the dry cycle. The right-hand, green Clean light indicates the cycle is complete and ready to unload. If the Clean light is blinking, see "Troubleshooting" section. A. Wash cycle B. Dry cycle C. Clean light 1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door. 2. Press CANCEL/DRAIN button once. The Cancel/Drain light will light up. 3. Close the door within 3 seconds. The dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes. You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure. 1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely. 2. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before restarting your new cycle. 3. Press CANCEL/DRAIN twice to reset the control. 4. Select new cycles and options. 5. Press START/RESUME and firmly close the door within 3 seconds. NOTE: If the door is not closed within 3 seconds of pressing Start/Resume, press START/RESUME again. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
Delay Hours
Use this option to run your dishwasher
during off-peak
hours. Local utility providers
recommend
using energy during
off-peak
hours when possible.
To delay the start
1.
Select a wash cycle and options.
2.
Press the delay button
to choose the number of hours to be delayed.
3.
Press START/RESUME
and firmly close the door within 3 seconds.
NOTE: Anytime the door is opened
(such as, to add a dish), the START/RESUME
button
must be pressed again, within
3 seconds
of closing
the door, to resume the delay countdown.
Control
Lock
Option
Use the Control
Lock option to avoid unintended
use of the dishwasher
between
cycles. When LOCK ON is lit, all
buttons are disabled.
The dishwasher
door can still be opened/closed
while the controls
are locked.
To turn
on the Lock
Press and hold HEATED DRY for 4 seconds.
LOCK ON will light up. If you press any pad while your dishwasher
is
locked, the light flashes 4 times.
NOTE: The dishwasher
cannot
run if the control
is locked.
To turn
off the Lock
Press and hold HEATED DRY for 4 seconds.
The light turns off.
Status
Indicator
Lights
ABC
Front Panel Lights
- The left light indicates
the dishwasher
is in the
wash cycle. The middle light indicates the dishwasher
is in the dry cycle.
The right-hand,
green Clean light indicates the cycle is complete
and
ready to unload. If the Clean light is blinking,
see "Troubleshooting"
section.
A. Wash cycle
B. Dry cycle
C.
Clean light
1.
Open the door slightly to stop the cycle. Wait for the spraying
action to stop before completely
opening
the door.
2.
Press CANCEL/DRAIN
button
once. The Cancel/Drain
light will light up.
3.
Close the door within 3 seconds.
The dishwasher
starts a drain cycle (if water remains in bottom
of dishwasher).
Let
the dishwasher
drain completely.
The Cancel/Drain
light turns off after 2 minutes.
You can interrupt
a cycle and restart your dishwasher
from the beginning
using the following
procedure.
1.
Open the door slightly to stop the cycle. Wait for the spraying
action to stop, then open the door completely.
2.
Check that detergent
dispenser
cover is still closed.
If cover is open, you will need to refill the detergent
dispenser
before restarting your new cycle.
3.
Press CANCEL/DRAIN
twice to reset the control.
4.
Select new cycles and options.
5.
Press START/RESUME
and firmly close the door within 3 seconds.
NOTE:
If the door is not closed within 3 seconds of pressing
Start/Resume,
press START/RESUME
again.
21