Kyocera ECOSYS M6030cdn ECOSYS M6030cdn/M6530cdn Operation Guide - Page 68

Installing and Setting up the Machine > Energy Saver function Energy Saver function If a certain period of time elapses after the machine is last used, the machine automatically enters sleep mode, which minimizes power consumption. If the machine is not used while in sleep mode, the power automatically turns off. Sleep and Auto Sleep NOTE If user login administration is enabled, you can only change the settings by logging in with administrator privileges. If user login administration is disabled, the user authentication screen appears. Enter a login user name and password, and select [Login]. The factory default login user name and login password are set as shown below. Login User Name: 3000 Login Password: 3000 Sleep To enter Sleep, select the [Energy Saver] key. Message display and all indicators on the operation panel will go out to save a maximum amount of power except the Energy Saver indicator. This status is referred to as Sleep. Energy Saver indicator If print data is received during Sleep, the machine automatically wakes up and starts printing. Also when fax data arrives while the machine is in Sleep, the machine automatically wakes up and starts printing. To resume, perform the following actions. • Select any key on the operation panel. The machine will be ready to operate within 17 seconds. Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly. Auto Sleep Auto Sleep automatically switches the machine into Sleep if left idle for a preset time. The default preset time is 1 minute. To change the preset sleep time, refer to the following: Sleep Timer (page 8-18) Follow the steps below to set the sleep timer for the machine to go into sleep mode when not in use. 1 Display the screen. [System Menu/Counter] key key > [Common Settings] > [OK] key key > [Timer Setting] > [OK] key key > [Sleep Timer] > [OK] key 2-20