Lantronix MPS100 EPS Reference Manual - Page 139
Set/Define Port Flow Control
![]() |
View all Lantronix MPS100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Command Reference 12.24.7 Set/Define Port Flow Control Set/Define Port Commands CTS DISABLED SET DEFINE PORT PortList ALL FLOW [ CONTROL ] ENABLED NONE XON Sets the type of flow control on the port, and whether flow control should be enabled for the port. For example, you can set the type of flow control to DSR/DTR, but have it disabled when you don't want flow control. Applies To EPS1, EPS2, EPS2-100, EPS4-100 Errors Modem Control and DSRlogout must be disabled if CTS/RTS or DTR/DSR flow control is selected. Parameters PortList/All Specifies a particular port or group of ports, or all ports. Port numbers are specified with integers between 1 and the total number of physical ports. Lists of ports must be separated by commas. Ranges of ports must be separated by a dash (-). Note: In the absence of a PortList or the All parameter, the configuration will affect the current port only. CTS Specifies CTS/RTS (hardware) flow control. Disabled Deactivates the configured flow control method. Enabled Specifies the configured flow control method. None Specifies no flow control (removes a CTS, DSR, or XON setting). XON Specifies XON/XOFF (software) flow control. Examples Local> SET PORT FLOW CONTROL DSR See Also Show/Monitor/List Ports, page 12-63; Flow Control, page 5-2. 12-19
![](/manual_guide/products/lantronix-eps2100-eps-reference-manual-3f43377/139.png)