Lenovo ThinkServer RD240 (English) Installation and User Guide - Page 70
Removing or installing the microprocessor fan duct
View all Lenovo ThinkServer RD240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Removing or installing the microprocessor fan duct This section provides instructions on how to remove or install the microprocessor fan duct. Removing the microprocessor fan duct Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information" on page iii and "Guidelines" on page 19. This section provides instructions on how to remove the microprocessor fan duct. To remove the microprocessor fan duct, do the following: 1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the server. 2. Remove the server cover. See "Removing the server cover" on page 21. 3. Slide the microprocessor fan duct a little bit backward to release the three plastic tabs from the chassis. Then, lift the microprocessor fan duct out of the chassis. Figure 51. Removing the microprocessor fan duct 4. To install the microprocessor fan duct, see "Installing the microprocessor fan duct" on page 58. Installing the microprocessor fan duct Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information" on page iii and "Guidelines" on page 19. This section provides instructions on how to install the microprocessor fan duct. To install the microprocessor fan duct, do the following: 1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the server. 58 ThinkServer User Guide